To drive a dowel nail onto a concrete surface, you will need an electric drill with a chipper or a hammer drill. For a brick surface, a brace or a hand drill is suitable. Be that as it may, a concrete drill will still be needed. Its diameter must be selected according to the size of the dowels, and the working part should be approximately 5 mm longer than the full length of the dowel. To work, you will also need a center punch and a hammer.
If you want to buy or sell in Armavir, we advise you to visit the bulletin board of armavir district, where you can place your ads or find the necessary goods and services on the posted ads.
When choosing a place for driving a dowel nail, you need to check the thickness of the wall so that you don’t break through it by drilling. It is also necessary to avoid getting into the electrical wiring, whether in channels inside the plates or gutters. When drilling concrete, avoid hitting metal reinforcement. When drilling brick structures, it is not necessary to make a hole in the cement section of the masonry due to poor fixation of the dowel.
After choosing a place for drilling, you need to knock out a small hole using a hammer and center punch (this is more about a hammer drill and an electric drill for concrete). When drilling, you need to start with low speed. After 5 mm deepening. drill speed can be increased. When drilling bricks, you need to be careful. After removing the dust from the finished hole, the dowel is inserted into it with light blows of the hammer for the entire length.
