Creation of slopes is one of the most disliked types of work by craftsmen. It requires high accuracy and experience, so leveling the slopes is a laborious and long process, and it is not always possible to achieve the required quality.
Looking for bath projects? Bath projects can be found at the link below. The site presents a project for a log cabin of a bath, projects for aerated concrete baths, a VIP bath project, etc. d.
There are only two effective ways to solve this problem – either with plaster, or with the help of cladding with additional materials.
Plaster is the cheapest material. First of all, you need to cover with tape all the elements where it should not go. The solution is prepared in a ratio of 1 to 3 – respectively, cement and sand. Water is added in such an amount that the solution keeps well on the trowel. The solution is applied in thin layers, each of which must dry for an hour, after which the last layer is leveled with a grater.
The slope itself is displayed using a level and half a meter. Somewhere the solution is added, somewhere removed. After that, the solution should dry, and the final processing is done with putty.
The second way is plasterboard finishing. It must be protected from moisture – usually such drywall has a green color. First you need to beat off the old plaster to the brick. After that, a drywall sheet is cut off and glued, and the void is filled with insulation or foam. For framing corners, you can buy decorative slats.
